Installing A Gbic Module - Cisco WS-G5484 Installation And Specification Manual

Release the GBIC module or SFP module.
Step 2
a.
b.
Step 3 Slide the GBIC module or SFP module out of the slot.
This completes the procedure to remove a GBIC module or SFP module from the Gigabit Ethernet
interface.

Installing a GBIC Module

Use the following procedure to install a GBIC module:
A horizontally oriented slot is shown for illustration purposes. Some chassis may have vertically
Note
oriented slots.
Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 1
Locate the alignment groove on the GBIC module (see the enlargement in
Step 2
Align the groove on the GBIC module with the interface opening (see
Step 3
Note
Figure 7
1
2
3
Gigabit Interface Converter (GBIC) Module and Small Form-Factor Pluggable (SFP) GBIC Module Installation Information and Specifications
OL-5067-08
Release the GBIC module from the slot by simultaneously squeezing the two plastic tabs (one on
each side of the GBIC module).
Release the SFP module. See
module.
GBIC modules are keyed to prevent incorrect insertion.
Inserting a GBIC Module with Alignment Groove on Top—Cisco 7301 Gigabit Ethernet
Interface Shown
5
1
GBIC module
Alignment groove
GBIC module port 0/1
Figure 11 for the various types of latches that may be on your SFP
3
2
E T H E R
N E T 0
/ 1
R X
G B I C
4
GBIC module port 0/2
5 Plug
Installing a GBIC Module
Figure 7 and Figure
Figure 7 and Figure
G I G A B
I T E T H
E R N E T
L I N K
T X
E N
R J 4 5
R X
8).
8).
4
0 / 2
G B I C
17