Makita DUT130 Instruction Manual page 9

Tighten the chuck by hand, and then place the
2.
chuck key in each of three holes and tighten it clock-
wise. Be sure to tighten the chuck key at all three holes
evenly.
1
2
► 1 . Chuck key 2. Chuck
To remove the shaft, turn the chuck key counterclock-
wise at one of the holes, and then loosen the chuck by
hand.
Installing the mixing blade
Optional accessory
Attach the mixing blade on the top of the shaft, and then
secure it with the hex bolt.
► 1 . Mixing blade 2. Shaft 3. Hex bolt
NOTICE:
Be sure to attach the mixing blade with
"UP" mark facing the tool.
1
► 1 . Mark
Hook
Optional accessory
hanging the tool with the hook.
tion or on potentially unstable surface.
3
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing or removing the shaft
1
holder
Optional accessory
2
For DUT131
1.
loosen the chuck with the hex wrench while holding the
spindle with the wrench.
3
► 1 . Hex wrench 2. Chuck 3. Wrench
9 ENGLISH
CAUTION:
Always remove the battery when
CAUTION:
Never hook the tool at high loca-
1
2
Insert the hex wrench into the chuck, and then
1
2
3
1
2
3