Operating The Nxs Keypad - Honeywell NX Series Pocket Programming Manual

Operating the NXS Keypad

Reading the Display
RUN and STOP
Indicate if the drive is
running. When RUN
blinks, STOP command
has been given but the
motor is still rotating.
LOCATION INDICATION
Displays the symbol and number of menu,
parameter etc.
Keypad Push-Buttons
LEFT
RESET
- In Menu: move backward
Reset active faults
- In parameter edit mode: move cursor left
Note: The motor may start immediately
- Exit edit mode
after resetting the fault!
Tip: Hold LEFT down 3s for
control place change LOCAL
<-> Remote
LEFT
- In menu: move forward
- In parameter edit mode: move cursor left
- In edit mode: exit
Tip: Hold LEFT down 3 – 5 s for
control place change
KEYPAD REMOTE
12
Проектирование. Монтаж. Продажа. - http://vskd.ru
DIRECTION READY
Active motor Lights up when AC power is on. In case of a fault,
direction visible: the symbol will not light up.
forward or
ALARM
reverse.
Lights up to warn that the drive is running outside
a certain limit.
FAULT
Indicates that unsafe operating conditions caused
the drive to stop.
CONTROL PLACE
Active control place is visible: keypad, I/O or
fieldbus.
DESCRIPTION LINE
Displays the description of menu, value or fault.
VALUE LINE
Displays the numerical and textual values of
references, parameters etc. and the number of
submenus available in each menu.
UP+ and DOWN-
UP+ and DOWN–
- Browse the pages in main and submenus
- Browse the pages in main and submenus
- Edit values
- Edit values
RIGHT
START AND STOP
- In Menu: move forward
- In parameter edit mode: move cursor right
Control the motor if the keypad is the active control
- Enter edit mode
RIGHT
- In menu: move forward
- In menu: enter edit mode
- In parameter edit mode: move cursor right
ENTER
- Confirmation of selections
- Fault history reset (2 – 3 s)
SELECT
Switch between the last two displays. To see how
the changed new value influences some other
value.