Administrator Settings-Multipoint Mode - Cisco TelePresence EX60 User Manual

65 Managing the Settings
Administrator Settings—Multipoint mode
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
To enter the Administrator Settings, you
must tap Administrator, located below
Restart, as outlined. This will take you to the
Administrator Settings right away.
Note that access to these settings may have
been password protected by your Video
Support Team.
About Mulipoint
There are basically two modes of
video conferencing; viz. MultiWay
and MultiSite.
•
To enable MultiWay, a MultiWay
address must have been entered.
•
If a MultiWay address has been
specified and MultiWay is selected,
MultiWay will always be used for
video conferencing.
•
If a MultiWay address has been
specified, but MultiSite is selected,
MultiSite will be used.
•
If set to Auto, MultiWay will be
used if a MultiWay address
has been specified, otherwise
MultiSite will be used.
•
If set to Off, no video conferencing
will be possible.
•
Any use of the MultiSite feature
requires the presence of the
MultiSite option.
Caution! There is no Cancel
function letting you exit the menu
undoing any changes you have
made. Take care!
D15016.07 User Guide Cisco TelePresence
EX60, EX90
Produced: October 2013 for TC6.3
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.