Test Run - Grizzly G0841 Owner's Manual

4. Connect conduit to electrical panel through
access hole (see Figure 24).
Terminal
Block
Figure 24. Location of electrical panel access
hole and terminal block.
5. Feed wires through conduit to electrical
panel. Make sure wires have enough slack
inside eletrical panel so they are not pulled
tight or stretched.
6. Connect ground wire to ground terminal (see
Figure 25), then connect incoming power
wires to power terminals (see Figure 25).
(Refer to G0841 Wiring Manual for detailed
wiring diagrams.)
Ground
Terminal
Figure 25. Terminal locations to connect ground
wire and incoming power wires.
7. Close and secure electrical panel door, then
perform Test Run in following section to
verify correct power phase polarity.
-28-
Access
Hole
Power
Terminals

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run verifies the following: 1) 3-phase
power supply polarity is correct, 2) the Emergency
Stop button safety features work correctly, and 3)
the motors power up and run correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Read and follow safety instructions at begin-
ning of manual, take all required safety pre-
cautions, and make sure all previous setup/
assembly steps in this manual have been
followed and completed.
2.
Clear all setup tools and loose items away
from machine.
3.
Make sure machine is disconnected from
power source (refer to Power Connection
on Page 27).
Model G0841 (Mfd. Since 06/18)