Table of Contents
Advertisement
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the STOP/ button safety feature functions prop-
erly (G1033X only).
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all tools and objects away from machine.
2.
G1033X Only: Push STOP button in.
3.
Connect machine to power supply.
4.
G1033X Only: Twist STOP button clockwise
until it springs out (see Figure 19). This
resets switch so machine can start.
Twist
Figure 19. Resetting STOP button (G1033X).
-20-
STOP Button
5.
Press START button to turn machine ON.
Verify motor starts up and runs smoothly
without any unusual problems or noises.
6.
Press STOP button to turn machine OFF.
7.
G1033X Only: WITHOUT resetting STOP
button, try to start machine by pressing the
START button. The machine should not start.
— If the machine does not start, the STOP
button safety feature is working correctly.
Congratulations! Test Run is complete.
— If the machine does start (with the STOP
button pushed in), immediately disconnect
power to the machine. The STOP button
safety feature is not working correctly and
must be replaced before further using the
machine. Call Tech Support for help.
Recommended
Adjustments
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom-
mend that you at verify the adjustments to ensure
the best possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in the SERVICE section starting on
Page 35.
Factory adjustments that should be verified:
Tensioning/replacing V-belts (Page 38).
•
Calibrating table height scale (Page 44).
•
Checking pulley alignment (Page 45).
•
After approximately 16 hours of operation,
V-belts will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of V-belts.
Refer to Tensioning/Replacing V-Belts on
Page 38 for detailed instructions.
Model G1033/X/Z (Mfd. Since 02/19)
Advertisement
Table of Contents
