Cisco NCS 2000 series Troubleshooting Manual page 546

Error Messages Reference
Error/Warning
ID
EID-3069
EID-3070
EID-3071
EID-3072
EID-3073
EID-3074
EID-3075
EID-3076
EID-3077
EID-3078
EID-3079
EID-3080
EID-3081
EID-3082
EID-3084
EID-3085
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
500
Error/Warning Message
The rising threshold must be greater than or equal to
the falling threshold.
Error in data for ports {0} Exactly one VLAN must be
marked untagged for each port. These changes will not
be applied.
An error occurred while retrieving the learned address
list.
An error occurred while clearing the learned address.
An error occurred while clearing the selected rows.
An error occurred while clearing the learned address
list by {0}.
At least one row in the parameter column must be
selected.
CTC lost its connection with this node. The NE Setup
Wizard will exit.
No optical link was selected.
An optical link could not be created.
Defaults cannot be applied to the node. {0}
CTC cannot navigate to the target tab. {0}
The port type cannot be changed.
The {0} extension byte cannot be changed.
An error occurred while retrieving laser parameters for
{0}.
No OSC Terminations were selected
Error Messages
Description
Refer to the error message text.
CTC encountered data error for the
specified ports. Only one VLAN
should be marked untagged for each
port.
Unable to retrieve the learned MAC
address from the NE.
Failure attempting to clear the learned
MAC address from a specific card or
Ether group.
Failure attempting to clear the learned
MAC address from a specific card or
Ether group.
Error encountered trying to clear the
learned MAC address from either a
VLAN or a port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
CTC cannot apply the defaults to the
specified node.
CTC cannot go to the specified target
tab.
Refer to the error message text.
You cannot modify the specified
extension byte.
There is no card, or there was an
internal communications error when
attempting to get the laser parameters
for the card.
Select an OSC termination and
proceed.