Otdr-Fiber-End-Not-Detected-Tx - Cisco NCS 2000 series Troubleshooting Manual

Hide thumbs Also See for NCS 2000 series:

Table of Contents

OTDR-FIBER-END-NOT-DETECTED-TX

Default Severity: NA

Logical Object: EQUIPMENT

The OTDR-FIBER-END-NOT-DETECTED-TX alarm is raised when the OTDR module cannot return a

valid fiber end.

Clear the OTDR-FIBER-END-NOT-DETECTED-TX Alarm

Execute the Auto Scan.

If the fiber is affected by high reflections or if the fiber is longer than 100 km, the fiber end cannot be found.

Hence, the alarm will not be cleared.

If the alarm does not clear, log into the Technical Support Website at

for more information or call Cisco TAC (1 800 553-2447).

OTDR-HYBRID-FAR-END-IN-PROGRESS

Default Severity: NA

Logical Object: EQUIPMENT

The OTDR-HYBRID-FAR-END-IN-PROGRESS alarm is raised when a hybrid scan is started on the remote

Clear the OTDR-HYBRID-FAR-END-IN-PROGRESS Alarm

Wait until the scan on the remote side is completed.

The time varies depending on the type of scan.

Alternatively, stop the scan by navigating to: Maintenance->DWDM->OTDR; select the side where the scan is ongoing

and click Cancel. The scan is stopped on both the sides.

If the alarm does not clear, log into the Technical Support Website at

for more information or call Cisco TAC (1 800 553-2447).

Cisco NCS 2000 series Troubleshooting Guide, Release 11.0

http://www.cisco.com/c/en/us/support/index.html

Alarm Troubleshooting