Cisco IE-4000 Software Configuration Manual page 499

Configuring LLDP, LLDP-MED, and Wired Location Service
Configuration Examples for Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LDP Parameters: Examples
This example shows how to configure LLDP parameters:
Switch# configure terminal
Switch(config)# lldp holdtime 120
Switch(config)# lldp reinit 2
Switch(config)# lldp timer 30
Switch(config)# end
Configuring TLV: Example
This example shows how to enable a TLV on an interface:
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end
Configuring Network Policy: Example
This example shows how to configure VLAN 100 for voice application with CoS and to enable the network-policy profile
and network-policy TLV on an interface:
Switch# configure terminal
Switch(config)# network-policy profile 1
Switch(config-network-policy)# voice vlan 100 cos 4
Switch(config-network-policy)# exit
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# network-policy profile 1
Switch(config-if)# lldp med-tlv-select network-policy
Configuring Voice Application: Example
This example shows how to configure the voice application type for the native VLAN with priority tagging:
Switch(config-network-policy)# voice vlan dot1p cos 4
Switch(config-network-policy)# voice vlan dot1p dscp 34
Configuring Civic Location Information: Example
This example shows how to configure civic location information on the switch:
Switch(config)# location civic-location identifier 1
Switch(config-civic)# number 3550
Switch(config-civic)# primary-road-name "Cisco Way"
Switch(config-civic)# city "San Jose"
Switch(config-civic)# state CA
Switch(config-civic)# building 19
Switch(config-civic)# room C6
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
495