Chain Brake - Husqvarna T536LiXP Workshop Manual

4. Disconnect the connection from the keypad.
5. Clean the surface where the keypad is attached.
6. Make sure the temperature is not lower than 15°C or
59°F. The surface where you attach the keypad
must not be more than ± 3°C or 5°F from the air
temperature. The temperature differs.
7. Remove the protective tape from the new keypad
and press the keypad onto the surface. Press the
keypad with 10 N/cm² for no less than 10 seconds.
8. Apply grease in the connector (A). Connect the
connector and apply grease on all sides (B).
A
B
9. Put the flat cable correctly in the crankcase.
18 - Repair instructions
2
10 N/cm
>10 sec
5.18.2 To disassemble the keypad
1. Remove the drive wheel cover, saw chain and guide
To remove the drive wheel cover and guide
bar. See
bar on page 9 .
2. Disassemble the crankcase. See
the crankcase on page 9 .
3. Disassemble the motor. See
motor on page 11 .
4. Disconnect the wire bracket from the control unit.
First disconnect (A) and then (B).
B
5. Disconnect the hand guard connector (B).
B
D
C
6. Remove the keypad (C).
7. Disconnect the main switch connection (D). See
remove the main switch on page 13 .

5.19 Chain brake

5.19.1 To disassemble the chain brake
WARNING: Use protective goggles. The inner
spring can eject out and cause injury.
1. Remove the drive wheel cover, saw chain and guide
To remove the drive wheel cover and guide
bar. See
bar on page 9 .
2. Disassemble the crankcase. See
the crankcase on page 9 .
3. Disassemble the motor. See
motor on page 11 .
To disassemble
To disassemble the
A
To
To disassemble
To disassemble the
539 - 003 - 05.12.2018