Control Unit S/N 2015100001 - Husqvarna T536LiXP Workshop Manual

3. Attach the screws to the control unit (D) and the
battery connection (E).
D
4. Connect the connector to the keypad and put the
connector together with the cables in the crankcase.
5. Put the motor connection with cable and the chain
brake sensor cables in the crankcase and assemble
the cable holder.
6. Connect the connector to the chain brake sensor
and attach it in its bracket.
7. Connect in the connectors to the main switch and
put the main switch into the crankcase.
8. Attach the connectors to the motor.
16 - Repair instructions
E
E
D
C
9. Make sure that the gray area in the illustration (A) is
free from cables. This is the battery ejector (B).
A
CAUTION: There is a risk that cables
around the battery ejector get caught
between other parts when the battery is
attached.
10. Assemble the product. See
wheel cover and guide bar on page 9 and To
assemble the crankcase on page 9 .

5.17 Control unit S/N 2015100001-

5.17.1 To disassemble the control unit
Note: Look at how cables and other components are
assembled before you disassemble. Be careful when
you assemble and make sure that the cables do not get
caught between other parts.
1. Disassemble the drive wheel cover, saw chain and
To remove the drive wheel cover and
guide bar. See
guide bar on page 9 .
2. Disassemble the crankcase. See
the crankcase on page 9 .
3. Disassemble the motor. See
motor on page 11 .
4. Remove the screws to the main switch and battery
terminal.
B
To assemble the drive
To disassemble
To disassemble the
539 - 003 - 05.12.2018