Motor - Husqvarna T536LiXP Workshop Manual

6. Turn the front handle guard down and away from the
product. Keep turning until the heel in the front
handle guard (C) is released from the heel in the
product (D).
C
5.11.2 To assemble the front hand guard
WARNING: Use protective goggles. The spring
in the hand guard can eject and cause injury.
1. Put the brake pin in its position.
2. Put the spring in its position and tension it.
3. Make sure the product can not move during the
following procedure.
4. Align the hand guard holding and hold the hand
guard in position.
B
A
A
539 - 003 - 05.12.2018
D
B
5. Pull the hand guard on to the holding on the left
side.
B
6. Put the spring into the slot on the hand guard.
7. Attach the screws (A and B).
8. Try the hand guard to make sure the hand guard is
attached correctly.

5.12 Motor

5.12.1 To disassemble the motor
CAUTION: Do not pull the wires.
1. Remove the drive wheel cover, the saw chain and
the guide bar. See
and guide bar on page 9
2. Remove the crankcase. See
crankcase on page 9
A
To remove the drive wheel cover
To disassemble the
Repair instructions - 11
B