Impeller - Husqvarna T536LiXP Workshop Manual

3. Remove the screws.
4. Press in holder (A) and disconnect the connector
(B).
B
A
5. Put a screwdriver (C) above the connector (D) and
carefully press down to release and disconnect the
connector.
6. Remove the motor.
5.12.2 To assemble the motor
CAUTION: Do not let the cables get caught
between other motor parts.
1. Put the motor on its brackets.
2. Connect the connectors.
3. Attach the chain brake sensor cable (C) to the
crankcase groove above the motor.
12 - Repair instructions
C
D
D
4. Make sure that the motor control cable (D) is on top
of the motor. If not, there is a risk that it comes loose
and gets caught in the clutch shaft.
5. Rotate the motor shaft until it aligns with the drive
shaft.
6. Attach the motor with the screws.
7. Assemble the product.
For motor with temperature sensor (–20140101) and
Gen. 1 control unit
Put the loose connector in the holder (D). No connection
is necessary.
For motor without temperature sensor (20140101–)
and Gen. 2 control unit
No connection is necessary.

5.13 Impeller

5.13.1 To disassemble the impeller
Note: The impeller can be removed with the motor
attached or removed.
1. Remove the drive wheel cover, the saw chain and
To remove the drive wheel cover
the guide bar. See
and guide bar on page 9 .
2. Disassemble the crankcase. See
the crankcase on page 9 .
C
D
To disassemble
539 - 003 - 05.12.2018