Hooking Up The Terminal - Honeywell temaserver TS TA series Installation Manual

Hooking Up the Terminal

To hook up the terminal, follow the steps described below (see Figure 5):
1. Attach the upper part of the terminal to the upper hooks on the support
plate.
2. Insert the cables into the terminal through the specified openings.
3. Tighten the two screws that secure the terminal to the support plate (use a
∅ 6mm parallel tip flat head screwdriver).
Hooking Up the Terminal
1) Attach terminal to hooks
3) fasten the screws
Figure 5: Hooking up the terminal
2) Insert
cables
Page 9