Installing And Removing Dangler Cables - Cisco 6200 Installation And Replacement

Installing and Removing Dangler Cables

4. Installing and Removing Dangler Cables
4.1 Installing Dangler Cables on the Cisco 6200
This procedure tells you how to attach dangler cables to the 50-pin Champ connectors on the back
of the Cisco 6200 DSLAM. (The Champs provide unshielded twisted pair (UTP) connections for
subscriber traffic.)
The dangler cables are numbered J1 through J10. Figure 4 and Table 1 show which Champ connector
each dangler cable should be attached to.
Figure 4
J9
Each dangler cable serves the subscriber line card (SLC) in a particular slot. The dangler cables
correspond to the SLC slots as shown in Table 1.
12 Cisco 6200 FRU Installation and Replacement
Attach Dangler Cables to Champ Connectors
J7
J5
J10
J6
J8
Rear view of Cisco 6200 chassis
J3
J1
J2
J4
78-5294-02 10/02/98
Do not attach
a dangler cable
to this connector