(2) Programming of the time-out time
The time-out value for receiving the data can be specified by the following procedure:
(3) Programming of the gateway number
The gateway number can be specified by the following procedure:
52
1.
Enter the PGM2 mode from the mode selection window.
2.
Select "SETTING" and press the
The SETTING window will appear.
3.
Select "MWS CONFIG" and press the
The MWS CONFIG window will appear.
4.
Move the cursor to the "TIME OUT" line.
Enter the time-out time (1-255 (sec)) and press the
• This value (time-out value) will depend upon the application.
Please consult your authorized SHARP dealer.
1.
Enter the PGM2 mode from the mode selection window.
2.
Select "SETTING" and press the
The SETTING window will appear.
3.
Select "MWS CONFIG" and press the
The MWS CONFIG window will appear.
4.
Move the cursor to the "G.W. ADDR. 4" line.
Enter the gateway number (0-254) and press the
• Entering a terminal number of the machine itself results in
"ENTRY ERROR".
• Entering a same number as pre-entered number in the IP
ADDRESS4 line results in "ENTRY ERROR".
e
key.
e
key.
c
key.
e
key.
e
key.
c
key.