Table of Contents
Advertisement
1
2
3
1. Lock nut
2. Abrasive disc
3. Rubber pad
4. Spindle
1
1. Lock nut wrench
2. Wrench
OPERATION
8
Fit the wool bonnet completely over the rubber pad and pull the string tight. Tie
004426
a bow knot and tuck the knot and any loose strings between the wool bonnet
and the rubber pad.
To remove the wool bonnet, follow the installation procedure in reverse.
Installing or removing abrasive disc
003414
NOTE:
•
Use sander accessories specified in this manual. These must be
purchased separately.
Mount the rubber pad onto the spindle. Fit the abrasive disc on the rubber pad
and screw the lock nut onto the spindle.
4
To tighten the lock nut, hold the spindle with the wrench so that it cannot
004427
revolve, then use the lock nut wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
2
Polishing operation by sponge pad
003479
CAUTION:
•
Always wear safety glasses or a face shield during operation.
In general, keep the sponge pad at an angle of about 15 degrees to the work-
piece surface.
Advertisement
Table of Contents
