Maintenance - Honeywell SiX Series Installation Instructions Manual

MAINTENANCE

Do not paint, and do not use cleaning agents, bleach
or polish the detector.
NOTE: Before performing any maintenance on the
detector, notify the proper authorities and
Central Station that maintenance is being
performed and the system will be temporarily
out of service. Disable the zone or system
undergoing maintenance to prevent any
unwanted alarms. Power must be removed from
the detector before performing maintenance of
any kind.
The SiXCO detector reports maintenance
issues to the control panel and communicates
them visually and audibly per the table below.
TROUBLE FEATURE
When the sensor (supervision) is in a trouble condition
(such as CO sensor end-of-life), the detector will send
a trouble signal to the control panel. Depending on the
issue, the detector must then be serviced or replaced.
NOTE: CO detectors are not to be used with detector
guards unless the combination is evaluated and
found suitable for that purpose.
MAINTENANCE
Do not paint, and do not use cleaning agents, bleach
or polish the detector.
NOTE: Before performing any maintenance on the
detector, notify the proper authorities and
Central Station that maintenance is being
performed and the system will be temporarily
out of service. Disable the zone or system
undergoing maintenance to prevent any
unwanted alarms. Power must be removed from
the detector before performing maintenance of
any kind.
The SiXCO detector reports maintenance issues
to the control panel and communicates them
visually and audibly per the table below.
TROUBLE FEATURE
When the sensor (supervision) is in a trouble condition
(such as CO sensor end-of-life), the detector will send
a trouble signal to the control panel. Depending on the
issue, the detector must then be serviced or replaced.
NOTE: CO detectors are not to be used with detector
guards unless the combination is evaluated and
found suitable for that purpose.
7