Table of Contents
Advertisement
Installing the Shelf Controller Cards and Fabric Cards
Table 8: SC and SC-SW LED Indicators
LED
Color
Status
Green
Yellow
Blinking yellow (slow)
Off
Attention
Blue
Every QSF LEDs, SFP LEDs, MGMT port LEDs, expansion port LEDs, and alarm LEDs are green when
Note
the port is working correctly. When the port is transmitting (Tx) and receiving (Rx) data, the LED flashes
green.
To confirm the location of the card that needs attention, the Attention LED can be lit by using the hw-module
Note
attention-led location command.
Troubleshooting the SC or SC-SW Card
If the installed card fails to operate or to power on after installation:
• Ensure that the card is seated firmly in the FCC slot. One easy way to verify physical installation is to
• Ensure that the ejector levers are latched and that the captive screws are fastened properly. If you are
• Examine the power system to see whether the FCC is receiving power.
About the Fabric Cards
The Cisco NCS 6000 switch fabric is a 3-stage cell-based architecture with six fabric planes. The S2 Fabric
Card (FC) and S2 FC2 cards implement the second stage of the switch fabric. The S13 Multi Chassis (MC)
FC and Universal fabric Card (UFC) cards implement the first and third stages of the switch fabric and reside
in the Cisco NCS 6008 Line Card Chassis (LCC). The FCs provide the switch fabric for the routing system
and perform the cross-connect function of the routing system, connecting every LC to each other. The switch
Description
The card is properly installed, and no faults are detected.
The software initialization is in progress during bootup, or a fault exists on the
board.
The card is not fully seated, or the slot has detected a parity error.
The card is not receiving power, or a power or hardware fault occurred. Verify
that there is power to the card by looking at the indicators on the power tray.
On: The card needs attention.
Off: The card does not require attention.
see whether the front faceplate of the card is even with the fronts of the other cards installed in the card
cage.
uncertain, unlatch the levers, loosen the screws, and attempt to reseat the card.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Troubleshooting the SC or SC-SW Card
77
Advertisement
Table of Contents
