Use Open (No Security) Associations With Funk; Select Microsoft As Your Security Choice; Select Microsoft Security - Honeywell Intermec CV41 User Manual

1. Make sure the communications and radio parameters on your computer are config-
2. Make sure Funk is selected as your security choice.
3. Start Intermec Settings.
4. Choose Communications > 802.11 Radio > Funk Security.
5. Select the profile you want to configure.
6. For 8021x choose None.
7. For Association, choose Open.
8. For Encryption, choose WEP.
9. Define a value for the keys you want to use. You can define up to four keys (Key 1
10. For Transmit key, choose the key you want to use for transmitting data.
11. Save your settings.

Use Open (No Security) Associations with Funk

Use the following procedure to configure your computer for open security using Funk.
1. Start Intermec Settings.
2. Choose Communications > 802.11 Radio > Funk Security.
3. Select the active profile you are using.
4. For Association, choose Open.
5. For Encryption, choose None.
6. Tap OK. Your settings are saved.

Select Microsoft as Your Security Choice

The default security setting is Funk. If you want to use Microsoft Wireless Zero Configu-
ration (WZC) security, you need to select it as your security choice. After you select Mic-
rosoft as your security choice, you will be prompted to save your settings and reset the
computer for your change to take effect.
With Microsoft as your security choice, you can configure:
•
•
•

Select Microsoft Security

Use the following procedure to select Microsoft security.
54
ured.
through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes long depending on
the capability of the radio. Set a 5-byte value for 64-bit WEP or a 13-byte value for
128-bit WEP. Hex keys must be preceded by 0x and contain 5 or 13 hex pairs.
WPA or WPA2
802.1x
Static WEP
CV41 Vehicle Mount Computer (Windows CE) User Guide