Table of Contents
Advertisement
5. Select the profile you want to configure.
6. For Association, choose WPA or WPA2. Encryption automatically defaults to TKIP
7. For 8021x, choose TTLS, PEAP, EAP-FAST, or TLS.
8. If you choose TTLS, EAP-FAST, or PEAP:
Note: The correct date must be set on your computer when you enable Validate Server
Certificate.
9. If you choose TLS:
Configure WPA or WPA2 Personal (PSK) Security With Funk
Use the following procedure to configure WPA-PSK or WPA2-PSK with Funk security.
1. Make sure the communications and radio parameters on your computer are config-
2. Make sure Funk is selected as your security choice.
3. Start Intermec Settings.
4. Choose Communications > 802.11 Radio > Funk Security.
5. Select the profile you want to configure.
6. For Association, choose WPA or WPA2.
7. For 8021x, choose None.
8. For Pre-Shared Key, enter the pre-shared key or passphrase.
9. Save your settings.
Configure 802.1x Security With Funk Security
Use the following procedure to configure 802.1x-WEP security with Funk security. Hon-
eywell recommends that you use WPA2-802.1x instead of 802.1x-WEP if possible.
52
or AES, respectively.
a. For Prompt for Credentials, choose Enter credentials now.
b. Enter a User Name and User Password.
c. For Validate Server Certificate, choose Yes.
a. Load a user and root certificate on your computer. For help, see
Certificate.
b. Enter a User Name and Subject Name.
c. For Validate Server Certificate, choose Yes.
ured.
The pre-shared key must be a value of 32 hex pairs preceded by 0x for a total of 66
characters. The value must match the key value on the access point. The passphrase
must be from 8 to 63 characters. After you enter a passphrase, the computer
internally converts it to a pre-shared key. This value must match the passphrase on
the authenticator.
CV41 Vehicle Mount Computer (Windows CE) User Guide
Load a
Advertisement
Table of Contents
