Gap Sensor Assembly - Honeywell PC42d Service & Repair Manual

TITLE
PC42d Service Repair Manual

Gap Sensor Assembly

OPERATION:
It is recommended that the Mylar be replaced when replacing gap sensor assembly
Tools Required
Description
Phillips Driver
Parts Required
Item Part Number
1 50129058-004FRE
2 50121888-001FRE
Gap Sensor Assembly Removal
1. Remove top and bottom enclosure. Refer to Top/Bottom Enclosure Assembly Section
2. Disconnect black mark sensor cable from MLB. See Figure 11.
3. Remove the sensor mounting screw. See Figure 12.
Model
L3-GLBL-RPR-4260
PC42d
(Rev A)
Description
FRE, PCBA, Gap Sensor Board
FRE, Plastite Screw, 100-Pack ( torgue value 2±0.1kgf/cm)
Figure 11 – Gap Sensor Assembly Connector
Removing
sensor
assembly
Figure 12
DOCUMENT NO.
Page 16 of 25
PAGE
1
Gap Sensor
L3-GLBL-RPR-4260 (Rev A)
Qty
1
1