Makita DRT50 Instruction Manual page 17

1
1. Workpiece 2. Bit 3. Guide roller
Using the tool with the tilt base
wing screws, then tilt the tool at the desired angle, and
then tighten the wing screws.
Firmly clamp a straight board to the workpiece and use it as a guide
against the tilt base. Feed the tool in the direction of the arrow.
1. Wing screw
Using the tilt base plate with the
trimmer base
plate from the tilt base, and then attach it to the trimmer base.
1. 2.
2
3
1
1 2
Using the tool with the offset base
such as a corner.
Using the trimmer base with the
offset base plate and grip
more stability.
1. Loosen the screws on the base plate, then remove
the base plate from the offset base.
1. Offset base plate 2.
2.
tightening the screws.
3.
the offset base plate by tightening the screws.
17 ENGLISH
1 2