Tour The Screen; Operating Tips; All Contents - Cisco TelePresence SX10 User Manual

Introduction

Tour the Screen

Upper left corner
of the screen
contains the More
icon (>) which
provides access
to Standby mode,
System information
and the Do Not
Disturb feature.
Tip When set to Do Not Disturb, ringtones are muted and call attempts made by
D1509716 User Guide
Cisco TelePresence SX10, SX20
others to reach you will appear as missed calls. You may, however, place calls as
Produced: September 2018 for CE9.5
All contents © 2010–2018
Cisco Systems, Inc. All rights reserved.
The Call button The Share button
located to the is located to
left in the lower the right in the
part of the lower part of the
display. display.
much as you like.
The Camera
Control menu icon
is located in the
upper right corner
of the display.
If a messaging
system exists
for your
system, access
messages from
here.
As default, there is a 60 minutes timeout on the Do not disturb (after which the
system will return to normal operation), but this may have been changed to a
different setting by your Video Support Team.

Operating tips

Use the Cursor controls the remote
control to move about the screen
and press OK/Enter to open the
selected menu field.
Use the Cancel key to exit a menu
(and return to the Home screen)
undoing any changes. Use the Back
key to go just one step back.
The remote control buttons are
described on the following pages.
The Intelligent Proximity feature
allows you to share, see and capture
content from a video system
wirelessly on your own device. You
can also use your own device to
control calls on the video system. See
also "Intelligent Proximity" on page
21.
4