D-Link DWS-1008 User Manual page 28

DWS-1008 User's Manual
Note: To avoid confusion, do not assign numbers as VLAN names. Every VLAN on a
DWS-1008 switch has both a VLAN name used for authorization purposes and a VLAN
number. VLAN numbers can vary uniquely for each switch and are not related to 802.1Q tag
values even when used.
Configuring a Default Route
If Web View and a DWS-1008 switch are in different subnets, you need to configure a default
route on the switch. To configure a default route, use the following command:
set ip route default gateway metric
To verify the change, use the following command:
show ip route
The following commands add a default route that uses gateway 10.10.20.19 with a path cost
of 1, and verify the change:
DWS-1008# set ip route default 10.10.20.19 1
success: change accepted.
DWS-1008# show ip route
Router table for IPv4
Destination/Mask
-----------------------
0.0.0.0/ 0
10.10.10.4/24
10.10.10.4/32
10.10.10.255/32
10.10.20.2/24
10.10.20.2/32
10.10.20.255/32
224.0.0.0/ 4
The 0.0.0.0 route is the default route. The 10.10.10.x and 10.10.20.x routes in this example
are automatically added by MSS when you configure the corresponding IP interfaces.
The 224.0.0.0 route is for IGMP snooping. MSS automatically places this route in the
configuration.
D-Link Systems, Inc.
Configuration (continued)
Proto Metric NH-Type
------- --------- ------------
Static 1 Router
IP 0 Direct
IP 0 Local
IP 0 Local
IP 0 Direct
IP 0 Local
IP 0 Local
IP 0 Local
Gateway VLAN:Interface
------------ --------------------
10.10.20.19 vlan:4:ip
vlan:2:ip
vlan:2:ip:10.10.10.4/24
vlan:2:ip:10.10.10.4/24
vlan:4:ip
vlan:4:ip:10.10.20.2/24
vlan:4:ip:10.10.20.2/24
MULTICAST
Configuration
23