Preliminary Checks; Table 2-2 Preliminary Checks - Honeywell UDC2300 Product Manual

Installation

2.3 Preliminary Checks

Introduction
Before you install the indicator, remove the chassis and make any preliminary checks
necessary that are listed in Table 2-2. Figure 2-2 shows the locations for jumper
placements.
Check Preliminary Check
Number
Input I Jumper Placement
1
4 Alarm Relay Action.
6

Table 2-2 Preliminary Checks

Check the internal jumper for INPUT 1 to make sure it
is set for the correct input type. The jumper is located at
position S101 on the printed wiring board. Figure 2-2
shows the location of the jumper and position
selections.
The indicator has been shipped with ALARM relays
configured for N.C. (Normally Closed). If you want to
change to N.O. refer to Figure 2-2, Jumper positions
W201 and W202:
W201 is the ALARM RELAY 1 jumper.
W202 is the jumper ALARM RELAY 2.
See Table 2-3 for Alarm Relay contact information.
See Alarm Relay Caution Note, Page 8.
UDC2300 Indicator Product Manual
Description
10/00