Honeywell CD3000M-2PH User Manual page 15

Honeywell
5.1.1 Auxiliary Terminals
Before connect or disconnect, make sure that the power, control cables and wires are
insulated from the voltage.
Terminal
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
** In alarm condition or without auxiliary voltage the coil is not energized. In normal condition
(no alarm) the coil is energized.
Auxiliary terminals
www.honeywell.com/imc
CD3000M-2PH from 125A to 700A
Description
Auxiliary supply voltage 230-460Vac (600V on request)
N.C. not connected
Auxiliary supply voltage 230-460Vac (600V on request)
N.C. not connected
Fan supply 240V (if mounted)
Fan supply 240V (if mounted)
Reset
Reset
+ Input command signal 4÷20mA, 0÷10V, SSR
- Input command signal 4÷20mA, 0÷10V, SSR
∅ Volt GND
Output + 8Vdc stabilized, 1mA max
+ Output command signal to CD3000 slave
- Output command signal to CD3000 slave
+ External HB Calibration command 24Vdc max
- External HB Calibration command 24Vdc max
Used for the future
NO HB relay alarm ** (coil not energized)
Common relay HB alarm
NC HB relay alarm ** (coil not energized)
12
User's Manual