Advertisement
INSTALLATION (CTX700/D)
NOTE:
• Take care not to damage the painted surfaces of the
motorcycle.
• Illustrations show CTX700 type, other type is
similar.
1.
Refer to the Installation Instructions for the separately
sold backrest bracket, install the backrest bracket on
the motorcycle.
2. Install the pad as shown.
3. Loosely install the assembled backrest as shown.
ASSEMBLED BACKREST
8 mm FLANGE BOLT
(short)
Included in the
Backrest Bracket.
4. Tighten all loosely installed hardware to the
5. Install the caps as shown.
(Reuse)
8 mm FLANGE
CAP NUT
Included in the
Backrest Bracket.
3 of 3
specifications in the torque chart.
• Left side shown, right side is the same.
Tighten.
• Repeat on the right side.
CAP
Tighten.
LEFT REAR GRIP
Advertisement
