Honda 08F73-MGS-A50 Installation Instructions

INSTALLATION
INSTRUCTIONS
Honda Dealer: Please give a copy of these instructions to your customer.

PARTS LIST

(2(
(5(
(((
(3(
No. Description
(1( Right saddlebag panel
(2( Left saddlebag panel
(3( Left emblem
((( Right emblem
(5( Push rivet
TOOLS AND SUPPLIES REQUIRED
Electric drill
Drill bit (( mm(
Plastic hammer
Drift (O.D. approx. 5 mm(
Isopropyl alcohol
Shop towel
USE AND CARE INFORMATION
• Check the accessory mounts frequently.
• When this accessor y becomes dir ty, rinse it
thoroughly with cool water to remove loose dirt, then
wipe with a clean cloth or sponge. Do not use a
brush to clean this accessory as it may scratch the
surface.
• Never use petroleum solvents such as gasoline,
thinner, or benzine to clean this accessory. Also do
not use acid or alkaline cleaners.
• Wipe up spilled brake or battery fluid at once as they
may damage the plastic surface.
© 2012 Honda Motor Co., Ltd. - All Rights Reserved.
Accessory
SADDLEBAG PANEL
P/N 08F73-MGS-A50
INSTALLATION
NOtE:
•
(1(
•
1.
Qty
1
1
1
1
2
2. Peel back an end of the adhesive backings on the
Peel back leaving a little adhered.
87963-MGS-A500
Application
COMMON
Heat the bonding surfaces with a hair dryer if the
ambient air temperature is below 70°F (21°C(.
the adhesive reaches full strength in 72 hours. Wait
at least 2( hours before riding your motorcycle.
Drill the right saddlebag lid in the position shown.
• Before performing this step, remove the
emblem from the right saddlebag.
• Remove any burrs from the edge of the hole.
ELECtRIC DRILL
(( mm bIt(
back of the right saddlebag panel as shown.
ADHESIVE bACKINGS
ADHESIVE bACKING
Peel back leaving a
little adhered.
Publication No.
Mll 13973
Issue Date
May 2012
RIGHt SADDLEbAG LID
RIGHt SADDLEbAG PANEL
ADHESIVE bACKINGS
Peel back leaving a little adhered.
1 of 2