INSTALLATION
INSTRUCTIONS
Honda Dealer: Please give a copy of this instruction to your customer.
PARTS LIST
No.
Description
(1)
Trunk rack
(2)
Washer
(3)
Rubber washer
(4)
6 mm Socket bolt
TOOLS REQUIRED
Hex wrench (5 mm)
Electric drill motor
Drill bit (3 mm, 6 mm, and 10.5 mm)
Awl
Torque wrench
Customer Information: The information in this Acces-
sory Installation Instruction is intended for use only by
skilled technicians who have the proper tools, equipment
and training to correctly and safely add equipment to your
motorcycle. These procedures should not be attempted
by "do-it-yourselfers."
TORQUE CHART
Be sure to tighten all bolts to their specified torque.
Item
6mm Socket bolt
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
CHROME TRUNK RACK
P/N 08L42-MCA-100
(1)
(2)
(3)
(4)
Q'ty
1
4
4
4
N·m
kgf·m
Ibf·ft
12
1.2
9
INSTALLATION
1. Open the trunk lid and remove the inner lid.
LOCK STAY
INNER LID
SCREW (13)
2. Position the template under the trunk lid by using the
two ejector pin marks as the guide, mark the center
of the two dots on the template with an awl.
MARKS
LEFT SIDE TEMPLATE
3. Repeat on the right side.
08L42-MCA-1004-91
Application
GL1800
December 2000
MOTORCYCLE'S
SCREW
HARNESS CONNECTOR
CONTROL BOX
EJECTOR PIN MARKS
Publications No.
Issue Date
TRUNK LID
TRUNK LID
1 of 3