Page 2
INSTALLATION (CTX700N/ND) 3. Loosely install the assembled backrest as shown. NOTE: ASSEMBLED BACKREST • Take care not to damage the painted surfaces of the motorcycle. 8 mm FLANGE CAP NUT • Illustrations show CTX700N type, other type is Included in the similar.
Page 3
INSTALLATION (CTX700/D) 4. Tighten all loosely installed hardware to the specifications in the torque chart. NOTE: • Left side shown, right side is the same. • Take care not to damage the painted surfaces of the motorcycle. Tighten. • Illustrations show CTX700 type, other type is similar.