Makita UR100D Instruction Manual page 13

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
Fig.7: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
Indicator lamps
Lighted
NOTE:
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
For your safety, this tool is
equipped with the lock-off button which prevents
the tool from unintended starting. Never use the
tool if it starts when you pull the switch trigger
without pressing the lock-off button. Ask your local
WARNING:
Never disable the lock function or
tape down the lock-off button.
NOTICE:
Do not pull the switch trigger forcibly
without pressing the lock-off button.
may break.
Fig.8: 1. Switch trigger 2.
Indication lamp
Running the tool allows the indication lamp to show the
battery cartridge capacity status.
Fig.9: 1. Lamp
When the tool is also overloaded and has stopped
the indication lamp.
Remaining
capacity
Off
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Indication lamp
in red.
in red. (Note 1)
in red. (Note 1)
the temperature around the work area and the battery cartridge
conditions.
Nylon cutting head
NOTICE:
Do not bump the tool to the concrete or
asphalt surface. Bumping to this kind of objects
may cause the tool damage.
NOTE:
bumping the head, rewind or replace the nylon cord
NOTE:
Fig.10: 1. Nylon cutting head 2. Cutter
against the ground while the tool is running. As the
the proper length by the cutter.
Plastic blade storage
Fig.11: 1. Plastic blade 2. Blade holder
blade, remove the battery cartridge.
Adjusting the position of the handle
and front grip
CAUTION:
Before adjusting the shaft length,
be sure to switch off the tool and remove the
battery cartridge from the tool. Failure to do so may
handle when lowering your right hand.
Fig.12: 1. Handle
lever.
Fig.13: 1. Lock lever
Fig.14: 1. Front grip
13 ENGLISH
Status Action to be taken
Recharge the
appropriate time to battery cartridge.
replace the battery
cartridge when
the battery power
becomes low.
Recharge the
when the battery battery cartridge.
power is almost
used up. At this
time, tool stops
immediately.
Autostop due to
overload.
-