Maintenance - Makita CA5000 Instruction Manual

2. Set the tool on the guide rail.
3. Align the guide rail along the cutting line with using
the guide plate. Make sure that the blade does not
make any contact with workpiece.
and wait until the blade attains full speed.
5.
cut, and simply move the tool forward over the work-
until the cutting is completed.
blade to stop and then withdraw tool.
To get clean cuts, keep your cutting line straight and
your speed of advance uniform. If the cut fails to prop-
erly follow your intended cut line, do not attempt to
may bind the blade and lead to dangerous kickback and
WARNING:
To avoid a kickback, be sure to
clamped on the guide rail.
Fixed stop
2.
button, and turn the tool on, then wait until the blade
attains full speed.
3.
depth of cut, and move the tool forward to the desired
plunge position.
NOTE: The triangular mark on the blade case shows
the approximate center of the blade.
. Doing so
1
1
Triangular mark

MAINTENANCE

CAUTION:
perform inspection or maintenance.
CAUTION:
system. A dirty guarding system may limit the proper
operation which could result in serious personal
cleaning is with compressed air.
NOTICE:
cracks may result.
Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
11 ENGLISH
1