4.6.2 Programming the Digital Output Menu
Velocity
0.0
m/s
Display
Display Format
Program
Program Review
Keypad Lockout
Enter the password
9999
]UNDO [
]SAVE
]MOVE
]MODF
User Preference
Settings
Units Setting
Density
Password
Input/Output
Analog Output A
Digital Output B
Digital Output C
Modbus/Service Port
Digital outputs can be programmed as
AquaTrans™ AT600 User's Manual
Digital Output
To access the
lock symbol and press [√]. The following screen opens.
Program
Select
and press [√]. The following screen opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
save. Then, press [
] to return to the previous screen.
User Preference
In the
menu, select
key. A screen similar to the following opens.
Select the desired
Digital Output
[
]
to enter the relevant configuration menu.
Note: The programming steps for
the same as those for
Pulse
Frequency
,
or
Chapter 4. Initial Setup and Programming
menu, on the initial screen, highlight the
Units Setting
with the [] or [] arrow keys, and press
Digital Output B
Digital Output A
.
Alarm
, or they can be turned
[
] t
o
and press the right arrow
Digital Output C
and
are
Off
.
51