Makita DUB362 Instruction Manual page 5

Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
Overheat protection for tool
On
When the tool is overheated, the tool stops automat-
ically, the battery indicator blink about 60 seconds. In
this situation, let the tool cool down before turning the
tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
light up for few seconds.
Indicator lamps
Lighted Off
Blinking
1
2
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Remaining battery capacity
indication
1
1. Battery indicator 2. CHECK button
Press the check button to make the battery indicators
indicators correspond to each battery.
Remaining battery capacity
indication
Battery indicator status
Blinking
On Off
5 ENGLISH
Off Blinking
malfunctioned.
2
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
Remaining
capacity
may have
1