Revert Channel - Kenwood NX-P500 User Manual

4
To end the scan at any time, press the button programmed as Scan button.
• The transceiver returns to the channel you were using before you started
scanning.

REVERT CHANNEL

The revert channel is the channel from which you start scanning. So, for example,
if you are on channel 1 when you begin to scan, your revert channel is channel 1.
During scan, pressing the PTT switch will automatically select the transceiver's
revert channel (in the above example, channel 1) and you will begin transmitting.
However, if you are currently paused on another channel after having received a
signal (for example, channel 2), pressing the PTT switch will allow you to transmit
on that channel, rather than returning to the revert channel. Scanning will resume
after 3 seconds, unless a signal is present on the channel.
35