Revert Channel; Squelch Level - Kenwood TK-3230DX Instruction Manual

4 To end the scan at any time, press and hold the
1 second.
• The transceiver returns to the channel you were using before
you started scanning.

REVERT CHANNEL

The revert channel is the channel from which you start
scanning. So, for example, if you are on channel 1 when you
begin to scan, your revert channel is channel 1.
During scan, pressing the PTT switch will automatically select
the transceiver's revert channel (in the above example, channel
1) and you will begin transmitting. However, if you are currently
paused on another channel after having received a signal (for
example, channel 2), pressing the PTT switch will allow you
to transmit on that channel, rather than returning to the revert
channel. Scanning will resume after 5 seconds, unless a signal
is present on the channel.
You can adjust the default squelch level of the transceiver.
1 Enter the Setting Mode {page 24}.
2 Press the
3 Press the MENU key then press
to select "
setting), or "
28

SQUELCH LEVEL

or key to select "
" (open), "
" (tight).
".
or
" (default
key for