Revert Channel - Kenwood TK-3130 Instruction Manual

You can turn the scan function (the ability to perform scan)
ON or OFF in Menu Mode:
1 Turn the transceiver power OFF.
2 Press and hold the MENU key while turning the
transceiver power ON (for 1 second).
3 Press the
4 Press the MENU key to select "SC-OF" (scan function off)
or "SC-On" (scan function on).
• If you select "SC-OF", you will no longer be able to perform
scan by pressing and holding the
5 Press the PTT, MON, or CAL key to exit Menu Mode.
R C
EVERT HANNEL
During scan, pressing the PTT switch will automatically select
the transceiver's revert channel and you will begin
transmitting. However, if you are currently paused at a
channel, pressing the PTT switch will allow you to transmit on
your current channel, rather than returning to the transceiver's

revert channel.

After transmitting on either your current channel or the revert
channel by pressing the PTT switch, the transceiver will wait
for 5 seconds before scanning continues. If a signal is
present on the channel before the 5 seconds elapse, the
transceiver remains on the channel until the signal is no
longer present. It then continues to function the same as
while scanning.
or key to select "SC".
key.
13