Advertisement
Installation procedure overview
Refer to the pages shown for details on each step.
Step
1. Install Flash Memory Module (if purchased separately)
Step
1
With the 900 Control Station positioned face forward, and with connectors on the bottom, locate the
Flash Memory Module receptacle through the access hole on the right side of the case.
2
Insert the Flash Memory Module into the connector, being sure the card is fully engaged in its
receptacle. Note the card is keyed to assure proper orientation.
Note
Control Station supports a minimum of 4MB and a maximum of 2GB Compact Flash memory card.
Note
The Flash Memory Module should not be installed or removed while the Control Station has power
applied.
51-52-33-157 Rev. 6
Rear
Action
See page
3
4
6
6
7
Face
Page 3 of 14
Hide quick links:
Advertisement
