Ac Power Supplies - Cisco 1100 Series Hardware Installation Manual

AC Power Supplies

AC Power Supplies
Overview of the AC Power Supply
Power supply of the Cisco 1100 Series ISRs is an external AC to DC power adapter. The external power
adapter DC power connector plugs in to the router 4-pin power connector, to power the unit.
Figure 16: Power Supply Unit
1
Installing and Removing SFP Modules
This section describes how to install optional small-form-factor pluggable (SFP) modules in the router to
provide optical Gigabit Ethernet connectivity.
The SFP module installs into a slot on the router rear panel. When selected in Cisco IOS software, it is assigned
port gigabitethernet 0/0/0. The default is the built-in RJ-45 1000Base-T connector, which is enabled on this
port.
Only SFP modules certified by Cisco are supported on the routers.
Table 12: SFPs Supported on the Router
Cisco Model
Number
GLC-EX-SMD
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
54
Minimum Description
IOS-XE Version
3.15 1000BASE-EX
SFP transceiver
module, SMF,
1310nm, DOM
Installing and Upgrading Internal Modules and FRUs
Power Cable