Ribbon Supply Assembly - Honeywell PM42 Service & Repair Manual

TITLE
PM42 Service Repair Manual

Ribbon Supply Assembly

OPERATION:
The ribbon supply assembly has reflective material that senses ribbon low. Ribbon low sensor assembly located
behind the ribbon supply assembly senses the reflective material and signal to the main logic board.
Tools Required
Description
Torx Driver T20
Parts Required
Item Part Number
1
2 50125990-001FRE
3
Ribbon Supply Assembly Replacement
1. Remove the torx screw securing the ribbon supply assembly module to the ribbon supply rod.
2. Pull the ribbon supply assembly module away from the ribbon supply rod. It is IMPORTANT to note the position of the
ribbon supply assembly guide pin attached to the spine (main deck).
3. Reverse the instructions for re-installation.
Model
PM42
Description
FRE, Assy, Ribbon Sensor, PM42
Figure 1
1
Ribbon Supply Assembly Module
DOCUMENT NO.
L3-GLBL-RPR-3872
(Rev A)
PAGE
Page 31 of 48
Qty
1
1
L3-GLBL-RPR-3872 (Rev A)