Media Guide Top Dancer Assembly - Honeywell PM42 Service & Repair Manual

TITLE
PM42 Service Repair Manual

Media Guide Top Dancer Assembly

OPERATION:
This section cover the replacement of top media guide dancer assembly and the dancer assembly.
Tools Required
Description
Torx T20
Torx T10
Parts Required
Item Part Number
1 50125904-001FRE
2 50125906-001FRE
3 50124625-002FRE
4 1-994059-012
Media Guide Top Dancer Assembly Replacement
1. Remove the torx screw securing the top media guide dancer assembly from the electronic side.
2. Disconnect the media sensor assembly from connector P20 on the main logic board (MLB) and slide the top
media guide dancer assembly away from the spine (main deck). It is
behind the spine (main deck) guide post, guide posts, and guide pin.
3. For Item #1 LSS upper assembly, the assembly can be removed without having to perform Step #1. LSS upper
assembly can be removed by detaching the assembly away from the guide pin.
4. For Item #2 Dancer Assembly, the assembly can be removed by removing the c-clip and slide the assembly
outward.
Screw securing media guide dancer assembly
Model
L3-GLBL-RPR-3872
PM42
(Rev A)
Description
FRE, Assy, Media Guide, Top, PM42 (complete
assembly include upper LSS sensor)
FRE, Assy, Dancer
FRE, Sensor Assembly, PM42 – Upper LSS
FRE, SCREW MRT M4X12 ZP, T20 (16±0.8kgf/cm)
4
DOCUMENT NO.
Page 22 of 48
IMPORTANT
Guide posts
PAGE
Qty
1
1
1
1
to note the spring position
Spring
L3-GLBL-RPR-3872 (Rev A)