Assembly - RIDGID R6000 Operator's Manual

ASSEMBLY

UNPACKING
This product has been shipped completely assembled.
n Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Drywall Screwdriver with Magnetic Bit Holder
and #2 Phillips Bit installed
R2 Square Recess Screwdriver Bit
Operator's Manual
WARNING:
If any parts are missing do not operate this tool
until the missing parts are replaced. Failure to
do so could result in possible serious personal
injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
PULL TO REMOVE
ADJUSTABLE
1/4 IN. PHILLIPS
SCREWDRIVER BIT
R2 BIT
ADJUSTABLE
NOSEPIECE
ADJUSTING
SLEEVE
NOSEPIECE
ALIGN AND PUSH TO
REPLACE ADJUSTABLE
NOSEPIECE
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
INSTALLING AND REPLACING BIT HOLDER
AND BITS
See Figure 2.
To install or replace bits:
n Install 1/4 in. screwdriver bits by inserting them into the
magnetic bit holder.
NOTE: It is not necessary to remove the adjustable nose-
piece to install or remove bits.
n Replace 1/4 in. screwdriver bits by pulling them out of
the magnetic bit holder.
To remove the magnetic bit holder:
n Pull the adjusting sleeve. The adjusting sleeve and adjust-
able nosepiece come off the gear casing as a set.
n Remove the magnetic bit holder. Pull the bit holder out
with pliers if you cannot remove it by hand.
To reassemble the bit holder and nosepiece:
n Push the bit holder into the hex opening of the spindle
until the ball lock snaps into the groove in the bit holder
shank.
n Attach the adjustable nosepiece to the gear case. Align
the raised tab inside the adjustable nosepiece with the
groove on the gear case and push the nosepiece until it
snaps into place.
GROOVE
GEAR
CASING
MAGNETIC BIT HOLDER
WITH 1/4 in. HEX OPENING
9
BELT CLIP
Fig. 2