Bake Burner And Ignitor; Broil Burner And Ignitor; Surface Burner Gas Valve; Back Panel - Maytag AGS1740BD series Service

Disassembly Procedures

Bake Burner and Ignitor

1. Turn off and disconnect electrical power and gas
supply to the range.
2. Remove oven door, racks and oven bottom.
3. Remove screws securing bottom bake cover.
4. Raise the back of the bake burner cover and slide
cover back to release the front edge of cover and lift
out of oven cavity.
5. Remove screws securing bake burner assembly to
the oven chassis.
6. Maneuver bake burner from the burner orifice and out
of the slotted location.
7. Pull forward on assembly to allow the ignitor terminal
plug to pass through the back of the oven cavity.
8. Disconnect terminal plug and remove assembly from
the oven cavity.
9. Remove screws securing ignitor to bake burner.
10.Replace and reassemble in reverse order.

Broil Burner and Ignitor

1. Turn off and disconnect electrical power and gas
supply to the range.
2. Remove oven door and racks.
3. Remove screws securing ignitor wire plate cover to
back of the oven cavity.
4. Maneuver ignitor wire terminal plug through the rear
of the oven cavity.
5. Disconnect ignitor wire terminal plug.
6. Remove screws securing broiler to oven cavity.
7. Carefully maneuver burner off of the broiler orifice
spud and remove from cavity.
8. Remove screws securing ignitor to broiler.
9. Remove wing nut securing flame spreader to broiler.
10.Replace and reassemble in reverse order.

Surface Burner Gas Valve

1. Remove control panel, see "Control Panel"
procedure.
2. Label and disconnect wire terminals from gas valve.
3. Remove knob on gas valve being replaced.
4. Remove front screws securing gas valve to control
panel.
5. Reverse procedure to reinstall gas valve.
28
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing.

Back Panel

1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove screws securing back panel to unit.
4. Remove screws securing outside edges of the back
panel to unit chassis.
5. Reverse procedure to reinstall back panel.

Control Panel

1. Remove power from unit.
2. Open oven door and remove screws securing control
panel.
3. Remove screws located on the right and left sides of
the control panel.
4. Grasp control panel on the far left and right sides and
gently pull the control panel out and down.
NOTE: Gently pull control panel out and down.
5. Remove gas valve control knobs, gas valves, and
electronic control/clock (as necessary) and transfer
to the new control panel.
6. Reverse procedure to reinstall control panel.

Electronic Control

1. Remove control panel, see "Control Panel"
procedure.
2. Remove screws securing electronic control bracket to
control panel.
3. Label and disconnect terminal wiring from electronic
control.
4. Reverse procedure to reinstall electronic control.
16026293
Electronic
Control
Control
Panel
©2005 Maytag Services