Meat Probe - Panasonic HL-BD82S Service Manual

HL-BD82S
4.2.2. Configuration
4.2.2.1.

Meat Probe

• The meat probe must be inserted when the message Prob
OFF is displayed. If everything is fine, the probe temperature
will be displayed instead of OFF.
Important: if the temperature display remains [OFF] quitting
the manual test, the meat probe option will not be enabled.
4.2.2.2. Functions
• Continue the test until S00 step is displayed: the control now
starts the steps to check all the oven outputs and inputs. The
active triangle near the tESt writing indicates the cavity
under test.
• Always press [+]
steps.
4.2.2.3. How to check Oven hardware
• S01: oven lights.
• S02: cooling fan.
• S03: convection fan. (ONLY FOR CONVECTION CAVITY)
• S04: check that no heating elements are energized. The
double line break relay must be open.
• S05: bottom element (3000W @240v 12,5) & (2253W
@208v 10,8A)
• S06: top element (3500W @240v 14,6) & (2629W @208v
12,6)
• S07: ring element
For single fan (2500W @240v 10,4) & (1877W @208v
9,0)
For double fans (2x1300W=2600W @240v 10,9) &
(1950W @208v 9,4)
Convection fans are also running. (ONLY FOR CON-
VECTION CAVITY).
• S08: additional element (1030W @240v 4,3A) & (775W
@208v 3,7A)
4.2.2.4. Dial Function
• S09: cooking mode selector. The display automatically
shows the off position value:
button to proceed to the following
• Turn the knob clockwise and check that the values corre-
spond to the ones in the following table:
Code ENGLISH
Multifunction
C00 Off
C01 Convection bake
C02 Convection broil
C03 Convection roast
C04 Fast preheat
C05 Bake
C06 Broil
C07 Dehydrate
C08 Self-clean
Once back in the off position, the control shows automati-
cally the step number again.
4.2.2.5. Temperature Function
• S10: temperature selector. The display automatically shows:
• (Default) in preset position.
• Turn the knob clockwise and verify that the temperature
changes between 170°f and 550°f. Verify that in clean posi-
tion the display shows:
• Once back in preset position, the control shows automati-
cally the step number again.
4.2.2.6. Finalization
• S11: press [options]
actually measured by the electronics. Press it again, then +
to come back to the step number.
• When the display shows the following message:
• Hold [options] and [fast preheat]
test and come back to the standard working mode.
6
to verify the temperature value
to quit the manual