Honeywell VISTA-128BPT Installation And Setup Manual page 8

Item Feature
Zone Abort Window (for
Programming non-fire zones)
(Abort
Window
Enable)
Zone Swinger Suppression
Programming Enable
(Swinger
Suppression
Enable)
Fire Alarm Verification
Zone
Programming
Tamper
Option
- Exit Time and
Progress
Annunciation/Disable
for Remote Arm (Not
Evaluated for SIA CP-
01)
-
Programmable Cross
Zoning Time
- Cancel Window
- Cancel Annunciation -
Keypad displays
"Alarm Cancel" when
report is received
User Duress Feature
Authority
Level 6
* Programming at installation may be subordinate to other UL requirements for the intended application.
** Combined Entry Delay and Abort Window should not exceed 1 minute.
NOTES:
• Using the Call Waiting Cancel feature on a non-Call Waiting line will prevent successful communication to the
central station.
• The control unit must be installed with a local sounding device and an off-premise transmission for Contact ID
communication format.
• Refer to the User Guide for procedures on Testing the System.
• During Test mode, no alarm reports are sent to the central monitoring station.
viii
Range
0 = no abort window
1 = yes, use abort
window according to
∗88 selection
0 = no suppression
1 = yes, suppress
alarms according to
∗84 selection
For Zone Response
Type 16 (Fire) tamper
selection must be set to
"0"
Always Enabled
Both zones must be
faulted within 5 minutes
5 minutes
NA
NA
Shipping
Default
1 = yes
Yes (enabled)
Disabled
Enabled
Per Manufacturer
Enabled
Enabled
Disabled
SIA
Requirement*
Yes (all non-fire
zones)
Yes (enabled (all
zones))
Enabled unless
sensors can self verify
Enabled
Per walk path in
protected premises
Not required to be
programmable
Enabled
Disabled