Cisco 800 series Configuring page 31

Configuring Radio Settings on an Access Point
Table 7 Feature Information for Configuring Radio Settings on an Access Point
Feature Name
IEEE 802.11d Support
IEEE 802.11g Support
Transmit Power Control
Wireless Access Point High-Speed WAN
Interface Card
World Mode
Feature Information for Configuring Radio Settings on an Access Point
Releases Feature Information
12.4T This feature provides support for 802.11d standards, which
allows you to set channels, transmission rates, and
power-save mode, among other configurable fields.
The following sections provide information about this
feature:
• Enabling and Disabling World Mode on an Access
Point, page 13
12.4T This feature provides support for 802.11g standards, which
allows you to set channels, transmission rates, and
power-save mode, among other configurable fields.
The following sections provide information about this
feature:
Configuring Radio and Client Device Power Levels on
•
an Access Point, page 6
12.4T This feature allows client devices to calculate the path loss
and the transmit power necessary for the client to reach the
access point, thereby extending client device battery life.
The following sections provide information about this
feature:
Configuring Radio and Client Device Power Levels on
•
an Access Point, page 6
12.4T This feature provides support for two new AP HWICs.
The following sections provide information about this
feature:
Configuring Radio and Client Device Power Levels on
•
an Access Point, page 6
12.4T This feature automates client configuration of channel and
transmit power settings allowing world-mode-enabled
access points to configure the settings on
world-mode-enabled clients. World mode is supported only
on the 2.4-GHz radio.
The following sections provide information about this
feature:
Enabling and Disabling World Mode on an Access
•
Point, page 13
31