Configuration Examples For Radio Settings On An Access Point - Cisco 800 series Configuring

Configuring Radio Settings on an Access Point
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
dot11 phone
Example:
Router(config)# dot11 phone
Step 4
end
Example:
Router(config-if)# end
Step 5
copy running-config startup-config
Example:
Router# copy running-config startup-config

Configuration Examples for Radio Settings on an Access Point

This section contains the following examples:
•
Configuring Radio Data Rates: Example
The following example shows how to disable the 1-Mbps data rate and set the rest of the data rates to
basic:
configure terminal
interface dot11radio 0
no speed basic-2.0 basic-5.5 basic-11.0
end
copy running-config startup-config
Configuring Radio Data Rates: Example
Configuration Examples for Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enables IEEE 802.11 compliance phone support.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.
27