Cisco 800 series Configuring page 26

How to Configure Radio Settings on an Access Point
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
fragment-threshold bytes
Example:
Router(config-if)# rts retries 30
Step 5
end
Example:
Router(config-if)# end
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
Configuring IP Phone Support on an Access Point
Perform this task to enable 802.11 compliance phone support.
Enabling IEEE 802.11 compliance phone support adds information to the AP beacons and probe
responses. This information helps some 802.11 phones make intelligent choices about the AP to which
they should associate. Some phones do not associate with an AP without this additional information.
SUMMARY STEPS
1.
2.
3.
4.
5.
26
enable
configure terminal
dot11 phone
end
copy running-config startup-config
Configuring Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters radio interface configuration mode.
The interface argument is in module/slot/port format,
•
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
•
port 1.
Sets the size at which packets are fragmented.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.