Cisco 800 series Configuring page 20

How to Configure Radio Settings on an Access Point
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
payload-encapsulation {rfc1042 | dot1h}
Example:
Router(config-if)# no dot11 extension aironet
Step 5
end
Example:
Router(config-if)# end
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
20
enable
configure terminal
interface dot11Radio interface
payload-encapsulation {rfc1042 | dot1h}
end
copy running-config startup-config
Configuring Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enters radio interface configuration mode.
• The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
•
port 1.
Specifies the encapsulation transformation method to RFC
1042 (SNAP) or dot1h (IEEE 802.1h).
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.